The Sacem Winds 400 is supplied without any attachments. The pump has a straight rigid 15mm diameter pipe output of length 55mm. This output can be used to give a simple jet fountain effect for use in a pebble pool for example or alternatively a length of flexible hose / garden hose with 13mm internal diameter may be stretched and pushed over its open end allowing further connection to a spout of some description.

Pump body length 58mm, width 42mm, height 46mm.

The Sacem Winds 800 kit comprises of a Sacem Winds 800 pond pump complete with fountain attachments.

Two attachments, a tee-piece with hose-tail and a fountainhead are included can be used to give one of the following combinations of output:

1. Flexible hose connection up to 13mm in diameter.
2. ½" BSP threaded connection for rigid pipefitting.
3. An extendable fountainhead adjustable in length from approximately 8" (20cm) to 14" (35cm).
4. Two outputs of either 1 with 2 or 1 with 3 from the above. Adjustment in flow split between the two outputs is achieved by means of a tap on the tee-piece which can be used to control or shut-off the flow in each tee-piece exit.

Pump body length 75mm, width 50mm, height 63mm.

The Sacem Spring 1001 kit comprises of a Sacem Spring 1001 pond pump complete with fountain attachments.

Three attachments, a tee-piece with hose-tail, a spray fountainhead and a bell fountainhead are included can be used to give one of the following combinations of output:

1. Flexible hose connection up to 13mm in diameter.
2. ½" BSP threaded connection for rigid pipefitting.
3. An extendable spray fountainhead adjustable in length from approximately 8" (20cm) to 14" (35cm).
4. A bell fountainhead that is 11" (285mm) long.
5. Two outputs of either 1 with 2, 1 with 3 or 1 with 4 from the above. Adjustment in flow split between the two outputs is achieved by means of a tap on the tee-piece which can be used to control or shut-off the flow in each tee-piece exit.

Pump body length 155mm, width 66mm, height 100mm.