This high quality stainless steel water feature is available in two sizes, i.e. the standard Rhine Flatbacked and the Tall Rhine. Both versions consist of a polished, mirror-finished, stainless steel central tower, which is rectangular in shape and hollow through the centre. The mirror finish is on every side of the central tower so it can be viewed from any angle. Water is pumped up through the centre and emerges from the top. If it is set-up in a vertical position then water flows down the mirror finished surfaces both at the front and at the back. The Rhine can be used indoor or outdoor and would be particularly attractive in a reception area. Each feature is available with an option of three different types of base. Alternatively it can be purchased without a base for use in an existing garden pond. Base options are as follows:

Easypond Base
Easypond bases can either be sunken into the ground or used on the surface and surrounded by a low wall for example. They are an easy way to make a pond with an exposed water surface.

Pebble Pool Base
These can be either sunken into the ground or used above the ground. They have a plastic disk, which covers the surface. This disk can be covered with stones, shale or pebbles, through which water from the feature will drain on its way back to the base.

Stainless Steel Base
The easiest option to install is to simply to get an attractive stainless steel base. This can be placed on your patio for example, and is as attractive as the feature is itself.